Where is the Reset button on Cisco router?

Press the Reset button located at the back of the device with a pin for approximately 15 seconds or until the power light on the front of the device starts flashing. The Router reloads and is set to the default configuration settings.

How do I reset my Cisco WiFi?

Use the System Configuration Setup page to restart the access point.
  1. Click “Warm” Restart System Now to perform a warm restart of the access point. A warm restart reboots the access point.
  2. Click “Cold” Restart System Now to perform a cold restart of the access point.

What happens if I reset my Cisco router?

Like most devices, they have a factory reset button that can be used to completely wipe the device. Factory resetting your Cisco router will remove all of your current settings, including your network name and WiFi password—so be sure to proceed with caution!

How do I reset my cisco 4500?

Resetting the Cisco IP switch to factory defaults
  1. Erase the existing configuration: write erase.
  2. Reload the switch software: reload. The system reboots and enters the configuration wizard. …
  3. In the configuration wizard, enter the basic switch settings: …
  4. When prompted, enter the user name and password to log in to the switch.

How do I reset my cisco 2911 to factory settings?

Reset Router to Factory Settings
  1. Type en to enter privileged mode.
  2. Type write erase to issue the erase comment.
  3. Type y to confirm erase command.
  4. Type configure t.
  5. Type config-register 0x2102 this tells the router to process existing config on startup.
  6. Type end.

What is default password for cisco router?

Most routers and switches by Cisco have default passwords of admin or cisco, and default IP addresses of 192.168. 1.1 or 192.168. 1.254.