How do I reset my bravos MCT dryer?

Full Reset

Disconnect the power to the Maytag dryer and wait 30 minutes. After 30 minutes, restore power and make a new selection. If the problem persists or the dryer will not operate, disconnect power once again and call Maytag for service.

How do I reset a Maytag Bravos washing machine?

Is there a reset button on Maytag washing machines? Unplug the washer for 1 minute from the electrical outlet.
…
How do you reset a Maytag Bravos washer?
  1. Press the “Power/Cancel” button.
  2. Push the appropriate button to choose a new cycle.
  3. Press “Start/Pause.” You have now reset your Maytag washer.

How do you reset the codes on a Maytag Bravos XL washer?

Write Down The Error Code!

Then press PAUSE/CANCEL once to clear the error code and try to start a new cycle. If code appears again put it through an automatic diagnostic cycle while you enjoy a nice soothing cup of tea. (Watch The Bravos Diagnostics Video) This will reveal any stored error codes.

How do I reset my Maytag control board?

Press and hold the Start/Pause button for 3 seconds. All indicator lights should be off at this point. Reset the Washer: To reset (clear) the washer, rotate the Cycle Selector Knob counter-clockwise (left) to clear any sequence.

How do you calibrate a Maytag Bravos MCT washer?

Is there a reset button on Maytag washing machines?

The Maytag washer doesn’t have a reset button. If you need the reset button, you have to use the ‘Power/Cancel’ button. Push it to stop the current cycle. Select a new cycle and then press ‘Start/Pause.

How do you run a diagnostic test on a Maytag washer?

How do I reset my Maytag washer language?

Changing the Language on Maytag Washer
  1. Press and hold the “Spin” and “Soil” button simultaneously for 10 seconds. A count down will be displayed on the console. Once the countdown has completed the unit will have successfully reset.
  2. Select the preferred language from the console.

Why is my Maytag washer stuck on sensing?

If your Maytag washer’s sensing light is stuck and will not move to the appropriate cycles, this is usually caused by a stuck or keypad. The keypad can occasionally become jammed or, if you have recently replaced a part on the washer, you may have forgotten to recycle the codes, which can lead to a stuck sensor light.